Orion 185LEDP Manuel d'utilisateur

18.5/21.5-INCH VALUE TFT-LCD MONITOR USER MANUAL Please read this manual thoroughly before use, and keep it handy for future ref

B. Remote Controller(Optional) 1. POWER() Turns the power ON or OFF. There will be a few seconds delay before the display appears. 2. SOURCE Selec

C. Bottom Key Control 1. SOURCE/ Selects an input source. Enters a submenu or accepts your selection in the OSD menu. 2. MENU Activates or exit

OSD Menu Description All picture, sound settings and setup for the monitor can be adjusted in the OSD menu. (On Screen Display) To adjust the

B. Picture/Sound Option Function Value Picture Mode Sets picture mode. See table below Color Tone Sets color tone. See table below Mut

Color Tone Cool Gives the white color a bluish tint. Normal Gives the white color a neutral tint. Warm Gives the white color a reddish tint. Use

C. PIP Option Function Value PIP Activates the PIP feature. Off or On Input Source Selects the input source for the PIP area. See table be

D. Setup Option Function Value Reset Resets the monitor settings to the factory default. Language Sets the language of the OSD menu. English,

Trigger Option Function Value Trigger Enable Activates the trigger feature. Off or On Trigger Input Selects the input source for the Trigger.

N/C(Normally Closed): The Trigger function is activated when the trigger cable is opened. N/O(Normally Opened): The Trigger function is activated

Wall mounting (Optional) The LCD monitor is suitable for wall mounting by using the VESA 100 standard wall mount (not included in the delivery).

▶ Pin Assignments Pin 1 RED VIDEO 9 2 GREEN VIDEO 10 SIGNAL CABLE DETECT 3 BLUE VIDEO 11 GROUND 4 GROUND 12 SDA(for DDC) 5 GROUND 13 H

Power Consumption Mode 18.5” 21.5” Turned On < 20W < 25W Turned Off < 1W LED Indicator The power management feature of the monitor is

18.5” 21.5” 18.5˝ Diagonal AM-TFT(Active-Matrix) 21.5˝ Diagonal AM-TFT(Active-Matrix) Pixel pitch(㎛): 300(H) x 300(V) Pixel pitch(㎛): 248.25(H)

WEEE Symbols - 21 - Correct Disposal of This Product (Waste Electrical & Electronic Equipment) (Applicable in the European Union and ot

MEMO

MEMO

MEMO

P/N : L39ME0222 Rev.0

SAFETY INSTRUCTION ………………………………………………………….…… 2 ~ 3CAUTIONS ……………………………………………………………... 4FCC RF INTERFERENCE STATEMENT ……

Important Safety Instruction 1. Read these instructions. 2. Keep these Instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do n

- The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed no the appa

CAUTION The power supply cord is used as the main disconnect device, ensure that the socket-outlet is located/installed near the equipment and is e

NOTE This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These l

Before setting up the monitor, ensure that the power to the monitor and other attached devices are turned off. ※ Notice: Stand & screws are o

A. Rear Connection 1. AV2 IN. 2. AV1 OUT. 3. AV1 IN. 4. TRIGGER IN. 5 & 6. AUDIO R & L (AV1 & AV2). 7. PC STEREO IN (VGA & DVI).